If you are using the device namely PR2000 for the first time, then from this blog you will get the whole information for setting up of the internet connection using the wired mode by using the method of NETGEAR genie or through the manual method using the steps of 192.168.0.1 wireless setup.
Here are the steps if you are using NETGEAR genie method Step 1: Before proceeding to the steps, just make sure that you are getting the right internet signal by just connecting through a computer using an Ethernet cable. Step 2: Just connect the Ethernet cable to the one end of the PR200 and connect the other end to the working internet source. Step 3: Slide the switch to the position of wired Step 4: Just plug the PR2000 into the outlet of the wall and wait for around 30 seconds. Note: You can also give supply to the PR200o with the help of the USB cable. Step 5: Make the connection of your device which is PR2000 using the method of wired connection of using the wireless connection. If you are using the wired computer, then just make sure that the you have safely attached the LAN port. Step 6: Using your computer or using your smart device just open your web browser and after opening you will be redirected to the NETGEAR genie. If you are having the blank page, then just visit the website which is http://www.routerlogin.com or http://192.168.168.1 into your address bar and press the enter button. Step 7: NETGEAR genie will take you to the process of installation and follow all the instructions that you are having on your screen. Step 8: After receiving the message of congratulations. Click on the option of take me to the Internet.
1 Comment
|
Archives
February 2018
Categories |